The Vents 100 Solid T fan with a timer is equipped with a check valve, this model operates with low noise and low consumption. Used as an exhaust fan to ventilate a bathroom, toilet or kitchen. It is mounted directly into the exhaust shaft; it can be connected through a small section of flexible or plastic air duct.
Fans with a timer are most often used to ventilate a toilet or bathroom. After turning off the lighting (or a separate switch), the fan will continue to operate for 2 to 30 minutes, after which it will automatically turn off. If you do not want the fan to turn on every time you visit the bathroom or toilet, it is recommended to switch it on to a separate switch.
Flat front grille of the fan with dimensions 160x160 mm.
Fan specifications
| Option | Size |
| Voltage, V | 230 |
| Current frequency, Hz | 50 |
| Power consumption, W | 7.5 |
| Maximum flow air, m3/h | 85 |
| Current, A< /strong> | 0.05 |
| Noise level at a distance 3 m, dB(A) | 25 |
| Weight, kg< /strong> | 0.51 |
| Protection | IP 44 |
| Pipe size, mm | 100 |
Dimensions
Description of the fan
- The Vents Solid 100 T fan can be used constantly or periodically. The motor provides low consumption of 7.5 W per hour.
- The housing, impeller and front panel of the fan are made of engineering ABS plastic, resistant to ultraviolet radiation for a long time.
- The fan is equipped with a reverse valve in the form of a film attached to the pipe. When the fan operates, the film opens slightly and allows the extracted air to pass through. When the fan is turned off, the valve prevents air from entering the exhaust duct into the room being served.
Control
The fan can be controlled from an external switch (not included in the delivery package) or turned on and off together with lighting from the light switch.
How a fan with a timer works
A fan with a timer is activated by an external switch, this can be a light switch. After turning off the lighting, the fan continues to work for the time set on the shutdown timer, which can be set in the range from 2 to 30 minutes, and turns off.
Connection diagram
The following wires must be connected to the terminal block in this modification of the fan:
- direct phase to terminal L
- phase through the light switch to terminal S
- zero to terminal N
Thus, for the fan to operate correctly, it is necessary to connect two wireswith a phase, one from the switch, the second with a constant phase.
Installation of the fan
The fan is mounted directly into the exhaust shaft of the apartment. Ceiling installation is allowed; in this case, a flexible or plastic air duct is connected to the fan branch pipe. The other end of the air duct is installed in the exhaust shaft. All joints and connections must be sealed using silicone, clamps and mounting tape. The fan housing is attached to the surface of the wall or ceiling using four screws, which are included in the delivery kit.
How to set the shutdown time
Remove the front cover of the fan. Under the cover you will see a potentiometer (labeled Toff in the figure) for adjusting the turn-off delay time. In order to set the time, you need to use the plastic screwdriver that comes with the fan. Do not use other objects for adjustment. When adjusting, do not use much force.
Turning clockwise increases the shutdown time to 30 minutes, turning counterclockwise reduces the delay time.
Installation example
< img src='/image/vent/1_bitovie/quiet/primer-montagha-5790.jpg' alt='Installing a Fan in the Bathroom'>
Warranty
Warranty for the fan is 5 yearssubject to compliance with the rules of transportation, storage, installation and operation.
User Guide
