Tees for flat and round ducts
A tee for flat and round ducts joins branches with different geometries.
A derivation distributes or collects flows and requires the coordination of sections and orientation. The branches must be considered within the full balance of the network.
There are no products to list in this category.
What to check to choose
- Section of the trunk and the branch
- Orientation of the branch
- Flows distribution
How to prepare the consultation
- Identify the equipment, connection or installation point where it will be used.
- Contrast measurements, working conditions and reference with system documentation.
- Check accessories, assembly and maintenance before confirming the selection.
Frequently asked questions
Is the air automatically distributed equally in the branches?
No. It depends on the resistance of each tour and the regulation provided for in the project.
What information does the consultation of this category make?
Provide the following information: Section of the trunk and the branch; Orientation of the branch; Flows distribution. Add the product reference and photographs of the site or existing component, where applicable.