Connecting sleeves
Connecting sleeves must match the connected ducts' cross-sections and insertion lengths.
The union must preserve the geometry of the route and the passage of the air. The accessories are chosen within a compatible system of measurements and fixations.
There are no products to list in this category.
What to check to choose
- Nominal measure
- Handle length
- Clamps or fasteners
How to prepare the consultation
- Identify the equipment, connection or installation point where it will be used.
- Contrast measurements, working conditions and reference with system documentation.
- Check accessories, assembly and maintenance before confirming the selection.
Frequently asked questions
Is it enough that two pieces look like the same diameter?
No. Check the fit measurements and if a sleeve, a joint or a specific fixation is required.
What information does the consultation of this category make?
Provide the following information: Nominal measure; Handle length; Clamps or fasteners. Add the product reference and photographs of the site or existing component, where applicable.