Bends for flat and round ducts
A bend for flat and round ducts combines changes of direction and cross-section in one component.
The spins modify the route and its pressure losses. It is necessary to check angle, radius and available space without deforming the ends of the accessory.
There are no products to list in this category.
What to check to choose
- measurements of both ends
- Angle and orientation
- Real mounting space
How to prepare the consultation
- Identify the equipment, connection or installation point where it will be used.
- Contrast measurements, working conditions and reference with system documentation.
- Check accessories, assembly and maintenance before confirming the selection.
Frequently asked questions
Can I substitute a curve for another one of different angles?
Only if the layout, the connections and the effect on the installation's losses are reviewed.
What information does the consultation of this category make?
Provide the following information: measurements of both ends; Angle and orientation; Real mounting space. Add the product reference and photographs of the site or existing component, where applicable.