Flat duct transitions
Choose a flat duct transition by the dimensions and alignment of its ends.
A change of section should be related to the flow and geometric continuity of the network. A connection that fits does not guarantee a correct dimensioning.
There are no products to list in this category.
What to check to choose
- Width and entrance height
- Output Section
- Displacement of axles
How to prepare the consultation
- Identify the equipment, connection or installation point where it will be used.
- Contrast measurements, working conditions and reference with system documentation.
- Check accessories, assembly and maintenance before confirming the selection.
Frequently asked questions
Does reducing the section always keep the same functioning?
No. Change the speeds and losses; the available flow and pressure must be checked.
What information does the consultation of this category make?
Provide the following information: Width and entrance height; Output Section; Displacement of axles. Add the product reference and photographs of the site or existing component, where applicable.