Connectors with dampers
A connector with a damper must match both the duct and the closing or regulating component.
The union must preserve the geometry of the route and the passage of the air. The accessories are chosen within a compatible system of measurements and fixations.
There are no products to list in this category.
What to check to choose
- Input and Output Geometry
- Actuating space
- Type of union
How to prepare the consultation
- Identify the equipment, connection or installation point where it will be used.
- Contrast measurements, working conditions and reference with system documentation.
- Check accessories, assembly and maintenance before confirming the selection.
Frequently asked questions
Is it enough that two pieces look like the same diameter?
No. Check the fit measurements and if a sleeve, a joint or a specific fixation is required.
What information does the consultation of this category make?
Provide the following information: Input and Output Geometry; Actuating space; Type of union. Add the product reference and photographs of the site or existing component, where applicable.