We assess installation of 4 mm SPC panels in Gandía, Playa de Gandía and La Safor to renew interior walls. Compare standard SPC and Domis Mineral finishes and conditions of use. The moisture-resistant material is suitable for bathroom and kitchen walls; the specific model and complete installation system must suit the intended exposure, with waterproofing and sealing at joints, corners and junctions where required.
There are no products to list in this category.
Material and system selection
SPC is stone polymer composite, a moisture-resistant material suitable for bathroom and kitchen walls. Check the specific model’s documentation for the intended conditions: ambient humidity, splashes or direct water contact. The substrate, adhesive, joints and junctions must form a compatible system. For showers and other areas exposed to water, specify the necessary waterproofing and seal joints, corners and junctions before completing the wall covering. Moisture resistance of the panel alone does not make the entire installation watertight.
Indicative prices and units
| Item | Unit | Excl. VAT | Incl. VAT |
|---|---|---|---|
| 4 mm SPC panel, 2880 × 1220 mm | panel | 150,00 € | 181,50 € |
| 4 mm Domis Mineral SPC panel | panel | 165,29 € | 200,00 € |
| Standard SPC + installation on a prepared wall | m2 | 67,54 € | 81,72 € |
| Domis Mineral + installation on a prepared wall | m2 | 71,89 € | 86,99 € |
| Liquid waterproofing on a prepared substrate | m2 | 18,00 € | 21,78 € |
| Waterproofing tape at corners and junctions | linear m | 6,00 € | 7,26 € |
| Site measurement and advice, up to 1 hour | visit | 40,00 € | 48,40 € |
| Minimum labour charge per separate site visit | minimum | 150,00 € | 181,50 € |
Site visits, travel and minimum labour charge
A site measurement and consultation lasting up to one hour in Gandía and Playa de Gandía costs 40,00 € excluding VAT / 48,40 € including VAT. Outside this area, the visit or delivery supplement is 1,00 €/km excluding VAT / 1,21 €/km including VAT; the chargeable route is specified in the quotation. The minimum labour charge per separate site visit is 150,00 € excluding VAT / 181,50 € including VAT.
Indicative prices are shown excluding VAT and including VAT at 21%. The final quotation depends on measurements, the cutting plan, access and the property’s condition. Panels and profiles are charged as complete panels and full-length bars. Electrical work at 230 V, wall chasing, substrate repairs, waste disposal charges and specialist lifting are quoted separately.
The tariff allows 600 ml of adhesive per panel. Before installation, compatibility with the panel model and substrate is confirmed. The specific adhesive and sealing work are stated in the quotation.
How the project is organised
- Measure and inspect the wall, access routes and room conditions.
- Prepare the surface: remove loose layers, level it and specify waterproofing where necessary.
- Install framing and backing board if included in the quoted solution.
- Fit panels using a compatible adhesive and complete trims and sealing according to the chosen system.
- Integrate profiles and LED lighting and configure the requested controls where included.
- Complete finishing, cleaning, bagging and waste removal according to the agreed scope.
Frequently asked questions
How are SPC panels selected for bathrooms and kitchens?
Choose a moisture-resistant model approved for the intended use in its documentation. Where splashes or direct water contact are expected, assess the complete system: panel, substrate, adhesive, waterproofing and sealing at joints, corners and junctions. Suitability of the finished installation cannot be established from the SPC name alone.
Is the price per m² the final project cost?
It is an indicative rate. The quotation is based on measurements and a cutting plan, taking access, substrate condition and finishes into account. Materials are charged in complete units; additional work and expenses are itemised.
How much does the measurement visit cost?
A site measurement and consultation lasting up to one hour in Gandía and Playa de Gandía costs 40,00 € excluding VAT / 48,40 € including VAT. Outside this area, the visit or delivery supplement is 1,00 €/km excluding VAT / 1,21 €/km including VAT; the chargeable route is specified in the quotation. The minimum labour charge per separate site visit is 150,00 € excluding VAT / 181,50 € including VAT.
What does the installation on prepared wall include?
The panel solution includes the quoted material, labour and adhesive for a prepared wall. Framing, repairs, waterproofing, profiles, lighting and other work are included only where expressly stated in the quotation.
Request a quotation for SPC panel installation in Gandía, Playa de Gandía and La Safor