Exhaust fan Vents 100 Flip T with a shutdown delay timer from 2 to 30 minutes. The small dimensions of the front grille 160x160 mm allows this model to be used for ventilation of a bathroom or toilet when a small-sized fan is required.
The Wave, Solid and Flip fan series differ from each other only in appearance view of the front grille.
Technical characteristics of the fan
| Parameter name | Value |
| Maximum productivity, m3/h | 85 |
| Consumption, W | 7.5 |
| Voltage, V | 220 |
| Current consumption, A | 0.05 |
| Impeller rotation speed, min-1 | 2000 |
| Sound pressure level at a distance of 3 m, dBA | 25 |
| Weight, kg | 0.51 |
| Protection class | IP 44 |
| Pipe size, mm | 100 |
Dimensions
Description of the fan
- Low noise and consumption. If you need to achieve completely silent operation, you can use the RS-1-300 performance controller (purchased separately). The regulator can turn the fan on and off and regulate performance.
- 24-hour or short-term operation is allowed.
- Consumption 7.5 W per hour.
- The housing and impeller are made of ABS plastic white. The material is impact-resistant, wear-resistant and does not emit harmful substances.
- The Vents Flip 100 fan is equipped with a check valve to prevent air from entering the shaft into the room being served.
Control
The fan can be turned on:
- from a separate switch (not included in the delivery package),
- turned on together with the lighting
- turned on from the PC regulator -1-300, which can also be used to regulate the performance of the hood.
Operating principle
A fan with a timer is activated by an external switch, this can be a light switch. After turning off the lighting, the fan continues to work for the time set on the shutdown timer, which can be set in the range from 2 to 30 minutes, and turns off.
How to connect a fan with a timer
The following wires must be connected to the terminal block in this modification of the fan:
- direct phase to terminal L
- phase through the light switch to terminal S
- zero to terminal N
Thus, for proper operation of the fan to the fan it is necessary to connect two wireswith a phase, one from the switch, the second with a constant phase.
Installation of the fan
The fan can be installed directly from the pipes into the ventilation shaft or through a short length flexible or plastic duct. The length of the air duct should be as short as possible, since the fan is axial and cannot create high pressure.
During installation, all connections between the fan pipe and the air duct or shaft must be sealed using sealant, clamps or mounting tape. If the hole in the wall is larger than the fan pipe, then you can use a rectangular wall plate with a round hole for mounting, which is purchased separately.
The fan housing is attached to the surface of the wall or ceiling using four self-tapping screws, which are supplied.
How to set the shutdown time
Remove the front cover of the fan. Under the cover you will see a potentiometer (labeled Toff in the figure) for adjusting the turn-off delay time. In order to set the time, you need to use the plastic screwdriver that comes with the fan. Do not use other objects for adjustment. When adjusting, do not use much force.
Turning clockwise increases the shutdown time to 30 minutes, turning counterclockwise reduces the delay time.
Installation example
< img src='/image/vent/statyy/vent-obsh/montagzhe-3486.jpg' alt='Installing a hood in the bathroom'>
Warranty
The warranty for this fan model is 60 months (5 years) subject to compliance with the rules of transportation, storage, installation and operation.
