Vents VUT 600 G is a supply and exhaust unit with heat recovery. Designed to create a supply and exhaust ventilation system for residential and commercial premises. This installation does not have a heater; the air is heated only through recuperation. The maximum consumption of the installation is only390 Wper hour.
The nominal capacity of this model is600 m3/h, the actual air flow depends on the aerodynamic resistance of the air duct network (length of air ducts, number of turns, grilles, etc.). This process is described in more detail below in the Recuperator section.
The unit is installed indoors with a positive temperature, the diameter of the air duct connection is 200 mm.
Casing
The unit casing is made of aluminum profile and sandwich panels with internal heat and sound insulation made of 20 mm thick mineral wool.
Filter
To filter supply and exhaust air, the unit has two built-in filters with a cleaning degree of G4 (exhaust) and F7 (supply).
Fans
The Vents VUT 600 G unit is equipped with supply and exhaust double-suction centrifugal fans with forward-curved blades and a built-in protection thermostat with automatic restart. Electric motors and impellers are dynamically balanced in two planes. Rolling ball bearings of electric motors do not require maintenance; their service life is at least 40,000 hours.
Recuperator
The cross-current recuperator is made of aluminum plates. For operation of the unit without recuperation, a “summer” liner is provided. Under the recuperator block there is a tray for collecting and discharging condensate. The supply and exhaust unit is equipped with a built-in system for protecting the recuperator from freezing during the cold season. Its essence is that the temperature sensor turns off the supply fan and the warm exhaust air warms up the recuperator. Then the supply fan turns on and the entire installation operates as usual.
Control
The fan rotation speed is controlled using a four-position switch, which allows you to select minimum, average or maximum speed or turn off the unit.
Specifications
| Parameter | Value |
| Voltage, V | 230 |
| Current frequency, Hz | 50 |
| Maximum fan power, W | 2x195 |
| Total installation power, W | 390 |
| Total current, A | 1.72 |
| Productivity, m3/h | 600 |
| Rotation speed, min -1 | 1350 |
| Noise level at a distance of 3 m, dB(A) | 32 -48 |
| Maximum temperature of transported air, C | -25....+55 |
| Weight, kg | 54 |
| Connected air duct size, mm | 200 |
Dimensions
| Dimensions | D | B | B1 | B2 | B3 | H | H1 | H2 | L | L1 |
| mm | 199 | 416 | 300 | 54 | 207 | 603 | 230 | 148 | 722 | 768 |
Diagram
Installation of the VUT G installation
The air handling unit is mounted on the floor, suspended from the ceiling using mounting bracket with vibration insert or mounted on the wall using brackets. The installation can be placed both in auxiliary rooms and in the main ones (behind a suspended ceiling, in a niche or in an open way). It can only be installed in such a position as to ensure collection and drainage of condensate. Access for service and filter cleaning is from the side panels.
Documentation
