Subcategories
Aluminum tapeChoose aluminium tape by th..
Duct clampsChoose clamps by the duct and..
Ducts and installation componentsInstall..
Ducts and installation components
Plan a duct network using cross-sections, changes of direction and compatible connections.
The useful section and the continuity of the unions affect the distribution of air. The layout should consider losses, fixations and access to maintenance.
Brand: Vents
Availability: In stock
For connection to an air duct with a diameter of 315 mm of an air duct at a right angle with a diameter of 200 mm. The tee 315/200 for ventilation mad..
from
37.50 €
Ex Tax:30.99 €
Brand: Vents
Availability: In stock
Tee for flat ducts 737 is used to connect three plastic air ducts with a cross-section of 60x120 mm to each other. Application For the formation of b..
from
8.18 €
Ex Tax:6.76 €
Brand: Vents
Availability: In stock
Tee for ventilation TM 100 is used to connect three air ducts with a diameter of 100 mm to each other. The shaped product is used to form branch units..
from
23.20 €
Ex Tax:19.17 €
Brand: Vents
Availability: In stock
The ventilation adapter PM 200/250 C is used in round air duct systems to connect two air ducts of different diameters to each other. It is one of the..
from
41.04 €
Ex Tax:33.92 €
Brand: Vents
Availability: In stock
Wall plenum FlexiVent 0832200x55/75x2 is designed for connecting two round air ducts with a diameter of 75 mm and a wall ventilation grille 200x55 mm...
from
41.08 €
Ex Tax:33.95 €What to check to choose
- Design section and flow
- System material
- Access to bonds and supports
How to prepare the consultation
- Identify the equipment, connection or installation point where it will be used.
- Contrast measurements, working conditions and reference with system documentation.
- Check accessories, assembly and maintenance before confirming the selection.
Frequently asked questions
Does a conduit of the same nominal measure always fit?
No. fit and tolerances depend on the system; it confirms the actual measurements and the compatible accessories.
What information does the consultation of this category make?
Provide the following information: Design section and flow; System material; Access to bonds and supports. Add the product reference and photographs of the site or existing component, where applicable.