Subcategories
Explore supply and installation options for decorative wall panels. Compare 8 mm WPC and 4 mm SPC according to the finish, room and substrate condition. Work in Gandía and Valencia is defined for each project; logistics and installation in the Balearic Islands require a separate proposal.
Material and system selection
Tongue-and-groove 8 mm WPC panels create a visually continuous wall finish. Select 4 mm SPC and the Domis Mineral range according to the finish and approved use of each product. A cutting plan establishes the number of complete panels and profile lengths needed before ordering.
SPC is stone polymer composite, a moisture-resistant material suitable for bathroom and kitchen walls. Check the specific model’s documentation for the intended conditions: ambient humidity, splashes or direct water contact. The substrate, adhesive, joints and junctions must form a compatible system. For showers and other areas exposed to water, specify the necessary waterproofing and seal joints, corners and junctions before completing the wall covering. Moisture resistance of the panel alone does not make the entire installation watertight.
Indicative prices and units
The installation rates in this table are indicative for projects in Gandía and Valencia. Balearic Islands projects require a separate quotation for logistics and labour.
| Item | Unit | Excl. VAT | Incl. VAT |
|---|---|---|---|
| 8 mm WPC panel, 2880 × 1220 mm | panel | 150,00 € | 181,50 € |
| 4 mm SPC panel, 2880 × 1220 mm | panel | 150,00 € | 181,50 € |
| 4 mm Domis Mineral SPC panel | panel | 165,29 € | 200,00 € |
| WPC + installation on a prepared wall | m2 | 67,54 € | 81,72 € |
| Standard SPC + installation on a prepared wall | m2 | 67,54 € | 81,72 € |
| Domis Mineral + installation on a prepared wall | m2 | 71,89 € | 86,99 € |
| WPC/SPC + framing + plasterboard + installation | m2 | 104,54 € | 126,49 € |
| WPC/SPC + framing + OSB + installation | m2 | 112,54 € | 136,17 € |
| Liquid waterproofing on a prepared substrate | m2 | 18,00 € | 21,78 € |
| Waterproofing tape at corners and junctions | linear m | 6,00 € | 7,26 € |
Site visits, travel and minimum labour charge
A site measurement and consultation lasting up to one hour in Gandía and Playa de Gandía costs 40,00 € excluding VAT / 48,40 € including VAT. Outside this area, the visit or delivery supplement is 1,00 €/km excluding VAT / 1,21 €/km including VAT; the chargeable route is specified in the quotation. The minimum labour charge per separate site visit is 150,00 € excluding VAT / 181,50 € including VAT.
Preparation and LED options
Indicative prices including VAT: removal of loose layers from 7,26 €/m²; one coat of primer on a prepared wall from 3,63 €/m²; continuous levelling up to 5 mm from 16,94 €/m². An LED line including profile, strip and installation starts at 31,46 € per linear metre. A 3 m LED line with a power supply starts at 160,93 €; with a power supply and Tuya dimmer, from 212,96 €. The scope is confirmed in the quotation.
Indicative prices are shown excluding VAT and including VAT at 21%. The final quotation depends on measurements, the cutting plan, access and the property’s condition. Panels and profiles are charged as complete panels and full-length bars. Electrical work at 230 V, wall chasing, substrate repairs, waste disposal charges and specialist lifting are quoted separately.
The tariff allows 600 ml of adhesive per panel. Before installation, compatibility with the panel model and substrate is confirmed. The specific adhesive and sealing work are stated in the quotation.
How the project is organised
- Measure and inspect the wall, access routes and room conditions.
- Prepare the surface: remove loose layers, level it and specify waterproofing where necessary.
- Install framing and backing board if included in the quoted solution.
- Fit panels using a compatible adhesive and complete trims and sealing according to the chosen system.
- Integrate profiles and LED lighting and configure the requested controls where included.
- Complete finishing, cleaning, bagging and waste removal according to the agreed scope.
Frequently asked questions
How are SPC panels selected for bathrooms and kitchens?
Choose a moisture-resistant model approved for the intended use in its documentation. Where splashes or direct water contact are expected, assess the complete system: panel, substrate, adhesive, waterproofing and sealing at joints, corners and junctions. Suitability of the finished installation cannot be established from the SPC name alone.
Is the price per m² the final project cost?
It is an indicative rate. The quotation is based on measurements and a cutting plan, taking access, substrate condition and finishes into account. Materials are charged in complete units; additional work and expenses are itemised.
How much does the measurement visit cost?
A site measurement and consultation lasting up to one hour in Gandía and Playa de Gandía costs 40,00 € excluding VAT / 48,40 € including VAT. Outside this area, the visit or delivery supplement is 1,00 €/km excluding VAT / 1,21 €/km including VAT; the chargeable route is specified in the quotation. The minimum labour charge per separate site visit is 150,00 € excluding VAT / 181,50 € including VAT.
What does the installation on prepared wall include?
The panel solution includes the quoted material, labour and adhesive for a prepared wall. Framing, repairs, waterproofing, profiles, lighting and other work are included only where expressly stated in the quotation.