This fan Vents Quietline 100 is intended for use in a supply or exhaust ventilation system. The fan is a duct fan, that is, it is built directly into a network of air ducts or plastic channels. This series of fans has a reduced noise level (this size Vents 100 Quietline is silent) and low energy consumption, which allows them to be installed directly in the rooms served by ventilation.
Design features
Thanks to the company’s own development 'Vents' managed to significantly reduce the noise level. Aerodynamic performance was achieved through a reasonable combination of the shape of the impeller and the rotation speed of the fan motor. The impeller in the fan is mounted on the electric motor shaft.
The fan housing and impeller are made of high-quality plastic, resistant to ultraviolet radiation. The fan uses a single-phase motor in a single-speed or two-speed version (Vents Quietline DUO fan). Built-in protection is used to protect against engine overheating.
Technical characteristics of the fan
| Parameter | Value |
| Productivity, m3/h | 100 |
| Power consumption, W | 7.5 |
| Voltage, V | 220 |
| Current, A | 0.049 |
| Speed impeller rotation, min-1 | 2100 |
| Noise level at a distance of 3 m, dBA | 25 |
| Weight, kg | 0.61 |
| Protection | IP X4 |
| Pipe size, mm | 100 |
Dimensions
| Dimensions | D | L |
| mm | 99 | 137.5 |
Diagram for connecting the fan to the network
Control
Manual
- any switch single-key type, installed in a distribution box. The connection occurs in exactly the same way as a household lighting switch (purchased separately).
- turning on, off and smoothly adjusting the fan performance using the RS-1-300 regulator (not included in the delivery package). Several fans can be connected to one such controller at the same time. In this case, the rule must be observed thatthe total power of these fans should not exceed 300 W.
Automatic control unit
- Using an electronic control unit BU-1-60 (see Electrical accessories). The control unit is supplied separately.
How to install the fan
- The Vents 100 Quietline fan is connected to an air duct with a diameter of 100 mm. If the duct diameter is smaller or larger, use a reducer or connector. When installed with flexible air ducts, the fan is attached using clamps to the wall or ceiling.
- The fan can be installed in a horizontal or vertical position. When installed vertically, it is necessary to provide protection from condensation or precipitation.
- The fan is intended for indoor installation only, outdoor installation is not allowed.
Vents Quietline installation examples
Vents Quietline 100 fan passport
