The Domovent 125 C1T fan with a timer is used for exhaust ventilation in apartments or houses. Installed in the exhaust duct directly or through the air duct. Provides air removal with a capacity of 179 m3/h, consumption does not exceed16 W per hour.
The built-in timer does not turn off the fan immediately after the switch is triggered, but with a time delay. The time can be set from 2 to 30 minutes independently. For example, a person leaves the kitchen and presses the switch. The fan continues to run for the set time and then turns off.
Technical characteristics
| Parameter< /strong> | Value |
| Voltage, V < /td> | 220 |
| Current frequency, Hz | 50 |
| Maximum power, W < /strong> | 16 |
| Productivity, m3/h | 179 |
| Current, A | 0.1 |
| Rotation speed, min-1 | 2300 |
| Noise level at a distance of 3 m, dB(A) | 44< /td> |
| Weight, kg | 0 ,75 |
| Protection, class | IP34 |
| Pipe size, mm | 125 |
Dimensions
| Dimensions | ?D | B | H | L* | L1< /td> |
| mm | 125 | 176 | 140 | 114 | 13 |
A fan with a timer is activated by an external switch, this can be a light switch.
Connection diagram
The following wires must be connected to the terminal block in this modification of the fan:
- straight phase to terminal L
- phase through the light switch to terminal LT
- zero to terminal N
Construction
- Thin front panel
- Insect mesh
- The fan housing and impeller are made of ABS engineering plastic. The material is resistant to damage and ultraviolet radiation.
- The aerodynamic shape of the impeller reduces consumption and increases service life
- Protection degree IP 34.
- The engine is equipped with overheating protection
How to install
The fan can be installed directly into the ventilation shaft opening or using a small air duct. Ceiling installation is allowed. When installing remotely, all joints must be sealed using sealant and clamps.
How to maintain
Household fans require periodic maintenance. Maintenance consists of periodically checking the condition of the terminal connections, cleaning the impeller and fan housing. Plastic parts must be cleaned using a soft cloth and soap solution. After cleaning, allow the parts to dry.
All servicing is carried out with the power turned off.
Passport
(pdf file, opens in a new tab)
