The air handling unit Vents VUE2 150 P EC Comfo is designed to provide ventilation for residential or commercial premises. It is a ready-made ventilation unit with a control system for working together with the air duct system. The installation is characterized by low consumption, which does not exceed 57 W per hour, due to the use of an anti-freeze system andtwo heat exchangers made of polymerized cellulose.
Maximum performance installation 170 m3/h.
Casing
The installation casing is made of aluminum-zinc steel. Thermal and sound insulation is made of mineral wool 20 mm thick.
Filtration
To filter supply and exhaust air, the unit uses two pocket filters with a purification degree of G4.
Fans
The unit is equipped with supply and exhaust centrifugal fans with backward-curved blades; EC motors with high efficiency and low noise and consumption levels are used.
Recuperators
The installation uses two cross-current recuperators made of polymerized paper.
Recuperators transfer sensible and latent heat from one air flow to another. They are frost-resistant and do not produce condensation. Thus, there is no need to drain drainage from this model into the sewer system.
Installation design
Control system
The unit is equipped with a built-in automation system and a multifunctional control panel with LED indication. Wall mounted control panel. Also included in the package is a remote control. To prevent the recuperator from freezing during the cold season, the unit is equipped with an active protection system. The temperature sensor stops the supply fan, while the warm exhaust air warms up the recuperators. The supply fan then turns on and the unit continues to operate as normal.
Operating modes
Using the air handling unit control system, you can perform the following actions:
- Turn the unit on/off,
- Selection of performance mode in a range of three speeds: minimum, average and maximum.
- Selection of operating mode according to a weekly schedule
- Timer mode allows you to switch the unit to maximum performance mode with automatic return to the previous speed after a set time in the range from 20 to 60 minutes
- Indication of the need to replace the filter.
It is also possible to connect CO2 sensors, humidity sensors or any other sensor (relay input), according to the signal of which can switch performance to maximum (All sensors are purchased separately and are not included in the delivery package).
Installation
The installation is intended for suspended ceiling or wall mounting. Can be installed on a balcony, pantry, basement, attic and other auxiliary rooms. The unit can also be installed in main rooms directly to the ceiling, behind a suspended ceiling or installed in a ceiling niche. Access for service from the bottom panel.
The unit does not have a drain pan, so it can also be installed vertically on a wall.
Specifications
| Parameter | Value |
| Voltage, V | 230 |
| Current, A | 0.55 |
| Current frequency, Hz | 50 |
| Maximum power consumption, W | 57 |
| Maximum productivity, m3/h | 170 |
| Rotation speed, min -1 | 3730 |
| Noise level at a distance of 3 m, dB(A) | 28 |
| Maximum temperature of transported air, C | -25....+40 |
| Heat recovery efficiency,% | up to 87 |
| Size of connected air ducts , mm | 125 |
