The Vents Flexivent 1001150/75x8 manifold is used to connecteight air ducts? 75 mmto the outlet of the fan or air handling unit? 150 mm.
Round ducts are connected using Flexivent flanges (supplied separately). Flange? 159, to which the fan is connected, is equipped with a rubber seal.
Material: steel with aluminum-zinc coating.
Dimensions
| D | L | A | H | |
| Dimensions, mm | 149 | 400 | 200 | 100 |
Pressure loss and air flow
| Flow rate, m3/h | Number of channels | Inflow of loss, Pa | Loss hood, Pa |
| 30 | 1 | 2.7 | 1.7 |
| 60 | 2 | 3.2 | 2.1 |
| 90 | 3 | 4.0 | 2.9 |
| 120 | 4 | 5.1 | 3.9 |
| 150 | 5 | 6,6 | 5.3 |
| 180 | 6 | 8.5 | 6.9 |
| 210 | 7 | 10.6 | 8.9 |
| 240 | 8 | 13.1 | 11.2 |
Installation
For air distribution along the channels it is necessary to use flanges that are inserted into the holes of the manifold. The channels are attached to such a flange using a lock on the flange. If some holes in the manifold will not be used, they are blocked with plugs with a seal (purchased separately).
Collectors can be installed under the ceiling; in this case, the main air duct from the unit or fan is connected from below.
Also, such a collector can be mounted on the floor; in this case, the channels are connected from below.
