Choose the comfort of motorization
Is your goal to upgrade your manual roller shutter (belt, handle, direct control)? Our complete set with motorized wire shaft is a solution that makes it easy to control your roller shutter with a switch. It's economical, you don't need to completely change your roller shutter. You just need to open its box and remove the previous shaft before replacing.
Determining compatibility with roller shutters
To find out if your tractor roll is compatible with a wired motorized shaft kit, make sure that:
- The previous shaft has a diameter of 40 mm and a length from 620 to 1500 mm
- The selected power corresponds to (see the calculation formula below)
*Approximate weight of lamellas: PVC 4 kg/m2, aluminum 4.5 kg/m2, wood 11 kg/m2.
Is the selected set power insufficient for the specified width? Choose a longer length and you will not use an additional telescopic shaft.
The composition of a set of wired motorized shaft ø40mm
- 1 - Octahedral axial roll 440mm -
The length of 1500mm can be shortened to the desired size - 2 - Wire motor ø40mm - Length 450mm - 9Nm (x1)
- 3 - Switch AvosDim ACCESVR_INT1 - installation overhead or internal (supplied)
- 4 - Wheel and crown of adaptation for octahedral axial shaft 40mm
- 5 - End tip ø40mm with ball bearing (x1)
- 6 - LS40/LT50 9500659 interface support
- 7 - Universal operator support 9910000
- 8 - Attachment of the sash in the form of a T (x3)
- 9 - Self-tapping screws (x3)
- 10 - Rotary plate with pin ø12mm 75 x 75mm (x1)
Technical data of the wired motor
- Diameter: 40mm
- Motor torque: 9Nm
- Rotation speed: 14 rpm
- Voltage: 230 V
- Power: 100W
- Consumption: 0.5 A
- Working time: 4 min
