Motorization of manual roller blinds
Control your hand-rolled curtain with the switch. There is no need to change everything with the PergolasVIP wired upgrade kit. Everything you need is in it! After assembling the shaft, just open the drawer to replace the old pipe with a new one, and then close it. It's so easy!
To find out if your roller blind is compatible with the 10Nm wired motorization kit, make sure that:
- The previous axis has a diameter of 60 mm and a length from 410 to 1500 mm
- The correct power has been selected (see the calculation formula below)
*Estimated weight of lamellas: PVC 4 kg/m2, aluminum 4.5 kg/m2, wood 11 kg/m2.
If your roller blind weighs up to 20 kg, then 10Nm is suitable.
Contents of the kit with a wired short axial motor ø60 mm 10Nm
- 1 - Octahedral axis ø60 mm - Length 1500 mm, Cut (x1)
- 2 - Pipe tip ø60 mm (x1)
- 3 - Rotary plate with pin ø12 mm 75 x 75 mm (x1)
- 4 - Motor mount
- 5 - Door-wall fastenings in the form of the letter T (x3)
- 6 - Wire motor ø45 mm 005163 -
Length 360 mm - 10Nm (x1)
- 7 - Wheel and gear suitable for octahedral axis 60 mm
- 8 - End position adjustment needle (x1)
- 9 - Self-tapping screws (x3)
- 10 - PergolasVIP switch for installation outside or inside (x1)
