General Airstage V-III AJG162LALBH Air Conditioner for Large Homes, Multi-Zone System
FUJITSU V-III Series VRF System is an advanced multi-zone system designed for efficient air conditioning in multi-story buildings and private homes. The system features a modern and laconic design, and also offers a wide range of models with a capacity from 8 to 54 hp in 2 hp increments, which allows you to connect up to 64 indoor units. The total capacity of the connected indoor units can reach 150%.
The high COP level is achieved thanks to unique technologies such as a special heat exchanger design, a powerful DC inverter compressor and a large fan. The system also offers the longest piping line in its class - up to 1000 meters, and the length of the route from the first branch pipe to the most remote indoor unit can be up to 90 meters. This greatly simplifies the design and installation of the system in buildings of any configuration.
High static pressure of 82 Pa allows you to connect an additional air duct to the outdoor unit, which makes it possible to install outdoor units in technical rooms of high-rise buildings. A comfortable indoor climate is maintained even during oil return, since the system continues to operate.
- Excellent energy savingsInverter heat pump: high energy savings in both cooling and heating thanks to All DC inverter technology to maximize seasonal efficiency.
- Easy installation and maintenanceEasy connection and flexible communication between units make our units and their maintenance easy to operate even in large ground-based systems.
- High static pressure of 82 PaThe outdoor unit can have an air exhaust duct with a static pressure of up to 82 Pa. This allows the outdoor unit to be installed inside the machine room and have the ability to carry out exhaust.
- Advanced operation controlWhen the units are connected to each other, the various compressors operate in a complex manner. Efficiency is significantly increased by the operation of the rotary compressor at low speed, distributing the force.
- Ideal heat exchanger controlThe heat exchanger is divided into 2 parts: upper and lower. The efficiency of heat exchange is increased by optimal management of the refrigerant, which is distributed to the upper part of the heat exchanger, where the flow of incoming air is greater.
Maximum efficiency in every operation
All our combinations have maximum technology and efficient consumption thanks to our
energy coefficients. Some advantages are possible thanks to our exclusive design of air access to the heat exchanger, our highly efficient DC Twin Rotary compressor and our innovative design, which increases the effective exchange surface up to 1.7 times.
