Air conditioner for high-rise buildings General Airstage V-III AJG360LALBHH
The FUJITSU Series V-III VRF system is a large multi-zone system that effectively conditions the air as in multi-storey buildings and in private houses. Laconic and modern design, wide model range with performance from 8 to 54 hp. in increments of 2 hp, the ability to connect up to 64 indoor units. The total performance of connected indoor units of the VRF series V-III TM FUJITSU system is up to 150%.
The highest COP level for any combination of units is achieved by a set of unique technologies, such as a special heat exchanger design, a powerful DC-inverter compressor, and a powerful large-diameter fan. Due to the longest pipe line length in its class of 1000 m, as well as the length of the route from the first splitter to the most distant indoor unit - up to 90 m, the FUJITSU TM VRF system is easy to design and select for any building layout.
High static pressure of 82 Pa makes it possible to connect an additional air vent to the outdoor unit. This allows you to install outdoor units in technical rooms of high-rise buildings. A comfortable indoor climate is maintained even during oil return, as the system continues to operate.
General Airstage V-III High-Rise Air Conditioner AJG360LALBHH
- Excellent Energy SavingsInverter Heat Pump: High energy savings in both cooling and heating thanks to All DC inverter technology to maximize seasonal efficiency.
- Easy Installation and MaintenanceEasy wiring and flexible communication between units make our units easy to operate and maintain, even in large ground-mounted systems.
- High Static Pressure of 82 PaThe outdoor unit can have an exhaust duct with a static pressure of up to 82 Pa. This allows the outdoor unit to be installed inside the machine room and still be able to exhaust.
- Advanced Operation ControlWhen the units are connected to each other, the different compressors operate in a complex manner. Efficiency is significantly increased by the rotary compressor operating at low speeds, distributing the force.
- Ideal heat exchanger controlThe heat exchanger is divided into 2 parts: upper and lower. Heat exchange efficiency is increased by optimal control of the refrigerant, which is distributed to the upper part of the heat exchanger, where the incoming air flow is greater.
Maximum efficiency of every operation
All our combinations have maximum technology and efficient consumption thanks to our
energy coefficients. Some advantages are possible thanks to our exclusive design of air access to the heat exchanger, our highly efficient DC Twin Rotary compressor and our innovative design, which increases the effective exchange surface up to 1.7 times.
